Sam Install Scripts

In response to some complaints on the Internet regarding the un-intuitive installer script for Symmantec's popular virus program SAM* 3.5. Symmantec's script will not do an installation if you have replaced the original Virus Definition file. Go figure! I don't know about you, but I update mine when necessary on the original disks. I have created my own scripts which should work fine. I have System 7.1, and I know it works there, but I also have created a System 6 installer. It should work fine, but I have no place to test it. Only the target folders have changed. These scripts only recognize the Virus Definitions file on the Decontamination Disk, so make sure that is where you place your updated Definition file. Also, it you are using System 7 or greater, SAM* Intercept and SAM* Intercept Jr. are both placed in the Extensions Folder. If you decide to use these, please just e-mail me and let me know that you have used it. Also, let me know about any troubles you may have. I can be reached at the following addresses: gt3017c@prism.gatech.edu or Heathen@aol.com My snail mail address is